Pointer Dynamometer Analog Push Pull Force Gauge Tester Meter Instruments(AL-NK-30)

Introduction:Analog Force Gauge with compact size,highaccuracy,they are easy to operate and handy to carry out,and can showthe unit of newton and kilogram at the same time.The PEAK/TRACKknob of it can switch between the peak value load test and thecontinuous load test.They are excellent products which can take theplace of the old style force gauges,andwidely applied inelectric,high & low voltage electricappliancehardwareautomobilepartslighter and ignition systemlightindustry mechanicaltextileandso on industries for test of pull or push load test insertion force or pulland destructive experimentPlease reading the manual carefully beforeusing this instrumentPreparation before testChoose appropriate joint clamps and install it on the gauge before test1Pull testChoose pull clamp and install it on the central stick of marked PULL2Push testChoose push clamp and install it on the central stick of marked PUSH(3)Use of prolong stickWhen it isn't possible to touch tested thing, use prolong stick to install clamp.NOTE:When testing, tested thing and gauge must be on the same straight line, if not, it isn't possible to test right value of load.(4)Confirm operation method of changing knob(a)[PEAK] change of [TRACK]Lightly press knob changing, at the same time, turn it to left to make mark "" be in the place of [TRACK].(b) [TRACK] change of [PEAK]Turn knob to right, the knob springs and mark "" is in the place of [TRACK].(C) Points for attention after testingAfter finishing testing, change mark "" , please put it in the place of [PEAK]. If changing knob is put in the place of [TRACK] for a long term, life of inner springs lam in will shorten.(5)Adjustments of indicator dial(a)Please confirm whether needle aims at [O] of dial, if not, please turn adjustable circle of dial, and dial will run with it to make needle aimed at [O].(b)When the machine is vertically placed to use, especially under the condition installing clamp, even don't apply load, needle will be lean, which is the dead weight reason of the machine and clamp. Turn adjustable circle of dial to have [O] aimed at needle, which can't affect veracity of testing result.NOTE:Usually give the machine to apply the load exceeding the range of Max. test load, spring of load test machinewill gradually be bad and lead to test value of load rightly. When using it, please don't overload to maintain life of the machine.==========Battery Included : NoHigh-concerned chemical : NoneModel Number : NKDisplay Type : AnalogUnit : N/KgLoad graduation value : 0.05NAccuracy : 1%Product Range : DynamometerProduct Type : AnalogProduct Model : Push Pull Force GaugeProduct specification : Force Gauge

• Pointer Dynamometer Analog Push Pull Force Gauge Tester Meter Instruments