Exit Loop - 4' X 12' or 6' x 10' Direct Burial Performed Loops with 60' Lead

Used for installations under concrete, asphalt, pavers, or in gravel roads. The most common installation is the loop tied directly to the rebar before concrete is poured. Wire is designed for a direct burial application. Unlike loops wrapped through PVC, The BD Loops Direct Burial Loop does not have an air pocket resulting in fewer repeat service calls due to phantom detections caused by ground vibration. Recommended installation tips for EL32-60 Preformed saw-cut Loop 4' x 12' or 6' x 10': - Offset the direct burial loop from the rebar pattern. - Always run the lead-in through conduit and glue the joint with a proper PVC solvent cement. - Run the lead-in in conduit underneath the rebar in a concrete pour. - Remove any ground stakes before burying the loop in a gravel or dirt road. - Fully encase the loop in sand when installing under pavers, or in a gravel road. (Show Encased in Sand Image) - Residential applications recommend a 4’ short leg of the loop. - Commercial application recommend a 6’ short leg of the loop.

• EL32-60 Preformed saw-cut Loop 4'x 12' or 6'x 10' loop with a 60' lead-in
• Used for installations under concrete, asphalt, pavers, or in gravel roads. The most common installation is the loop tied directly to the rebar before concrete is poured. Wire is designed for a direct burial application. Unlike loops wrapped through PVC, The BD Loops Direct Burial Loop does not have an air pocket resulting in fewer repeat service calls due to phantom detections caused by ground vibration.
• Fully encase the loop in sand when installing under pavers, or in a gravel road.
• Residential applications recommend a 4’ short leg of the loop.
• Commercial application recommend a 6’ short leg of the loop.